Solar Fe abundance and magnetic fields - Towards a consistent reference metallicity

We investigate the impact on Fe abundance determination of including magnetic flux in series of 3D radiation-MHD simulations of solar convection which we used to synthesize spectral intensity profiles corresponding to disc centre. A differential approach is used to quantify the changes in theoretical equivalent width of a set of 28 iron spectral lines spanning a wide range in lambda, excitation potential, oscillator strength, Land\'e factor, and formation height. The lines were computed in LTE using the spectral synthesis code LILIA. We used input magnetoconvection snapshots covering 50 minutes of solar evolution and belonging to series having an average vertical magnetic flux density of 0, 50, 100 and 200 G. For the relevant calculations we used the Copenhagen Stagger code. The presence of magnetic fields causes both a direct (Zeeman-broadening) effect on spectral lines with non-zero Land\'e factor and an indirect effect on temperature-sensitive lines via a change in the photospheric T-tau stratification. The corresponding correction in the estimated atomic abundance ranges from a few hundredths of a dex up to |Delta log(Fe)| ~ 0.15 dex, depending on the spectral line and on the amount of average magnetic flux within the range of values we considered. The Zeeman-broadening effect gains relatively more importance in the IR. The largest modification to previous solar abundance determinations based on visible spectral lines is instead due to the indirect effect, i.e., the line-weakening caused by a warmer stratification on an optical depth scale. Our results indicate that the average solar iron abundance obtained when using magnetoconvection models can be 0.03-0.11 dex higher than when using the simpler HD convection approach. We demonstrate that accounting for magnetic flux is important in state-of-the-art solar photospheric abundance determinations based on 3D simulations.Comment: 12 pages, 7 figures, A&A in pres

Thermal stress-induced charge and structure heterogeneity in emerging cathode materials

Nickel-rich layered oxide cathode materials are attractive near-term candidates for boosting the energy density of next generation lithium-ion batteries. The practical implementation of these materials is, however, hindered by unsatisfactory capacity retention, poor thermal stability, and oxygen release as a consequence of structural decomposition, which may have serious safety consequences. The undesired side reactions are often exothermic, causing complicated electro-chemo-mechanical interplay at elevated temperatures. In this work, we explore the effects of thermal exposure on chemically delithiated LiNi0.8Mn0.1Co0.1O2 (NMC-811) at a practical state-of-charge (50% Li content) and an over-charged state (25% Li content). A systematic study using a suite of advanced synchrotron radiation characterization tools reveals the dynamics of thermal behavior of the charged NMC-811, which involves sophisticated structural and chemical evolution; e.g. lattice phase transformation, transition metal (TM) cation migration and valence change, and lithium redistribution. These intertwined processes exhibit a complex 3D spatial heterogeneity and, collectively, form a valence state gradient throughout the particles. Our study sheds light on the response of NMC-811 to elevated temperature and highlights the importance of the cathode's thermal robustness for battery performance and safety

Solar Oscillations and Convection: II. Excitation of Radial Oscillations

Solar p-mode oscillations are excited by the work of stochastic, non-adiabatic, pressure fluctuations on the compressive modes. We evaluate the expression for the radial mode excitation rate derived by Nordlund and Stein (Paper I) using numerical simulations of near surface solar convection. We first apply this expression to the three radial modes of the simulation and obtain good agreement between the predicted excitation rate and the actual mode damping rates as determined from their energies and the widths of their resolved spectral profiles. We then apply this expression for the mode excitation rate to the solar modes and obtain excellent agreement with the low l damping rates determined from GOLF data. Excitation occurs close to the surface, mainly in the intergranular lanes and near the boundaries of granules (where turbulence and radiative cooling are large). The non-adiabatic pressure fluctuations near the surface are produced by small instantaneous local imbalances between the divergence of the radiative and convective fluxes near the solar surface. Below the surface, the non-adiabatic pressure fluctuations are produced primarily by turbulent pressure fluctuations (Reynolds stresses). The frequency dependence of the mode excitation is due to effects of the mode structure and the pressure fluctuation spectrum. Excitation is small at low frequencies due to mode properties -- the mode compression decreases and the mode mass increases at low frequency. Excitation is small at high frequencies due to the pressure fluctuation spectrum -- pressure fluctuations become small at high frequencies because they are due to convection which is a long time scale phenomena compared to the dominant p-mode periods.Comment: Accepted for publication in ApJ (scheduled for Dec 10, 2000 issue). 17 pages, 27 figures, some with reduced resolution -- high resolution versions available at http://www.astro.ku.dk/~aake/astro-ph/0008048

Solar convection and magneto-convection simulations

Magneto-convection simulations with two scenarios have been performed: in one, horizontal magnetic field is advected into the computational domain by fluid entering at the bottom. In the other, an initially uniform vertical magnetic field is imposed on a snapshot of non-magnetic convection and allowed to evolve. In both cases, the field is swept into the intergranular lanes and the boundaries of the underlying mesogranules. The largest field concentrations at the surface reach pressure balance with the surrounding gas. They suppress both horizontal and vertical flows, which reduces the heat transport. They cool, become evacuated and their optical depth unity surface is depressed by several hundred kilometers. Micropores form, typically where a small granule disappears and surrounding flux tubes squeeze into its previous location

Probing 5f-state configurations in URu2Si2 with U L3-edge resonant x-ray emission spectroscopy

Resonant x-ray emission spectroscopy (RXES) was employed at the U L3 absorption edge and the La1 emission line to explore the 5f occupancy, nf, and the degree of 5f orbital delocalization in the hidden order compound URu2Si2. By comparing to suitable reference materials such as UF4, UCd11, and alpha-U, we conclude that the 5f orbital in URu2Si2 is at least partially delocalized with nf = 2.87 +/- 0.08, and does not change with temperature down to 10 K within the estimated error. These results place further constraints on theoretical explanations of the hidden order, especially those requiring a localized f2 ground state.Comment: 11 pages,7 figure

Uncertainties of Synthetic Integrated Colors as Age Indicators

We investigate the uncertainties in the synthetic integrated colors of simple stellar populations. Three types of uncertainties are from the stellar models, the population synthesis techniques, and from the spectral libraries. Despite some skepticism, synthetic colors appear to be reliable age indicators when used for select age ranges. Rest-frame optical colors are good age indicators at ages 2 -- 7Gyr. At ages sufficiently large to produce hot HB stars, the UV-to-optical colors provide an alternative means for measuring ages. This UV technique may break the age-metallicity degeneracy because it separates old populations from young ones even in the lack of metallicity information. One can use such techniques on extragalactic globular clusters and perhaps even for high redshift galaxies that are passively evolving to study galaxy evolution history.Comment: 38 pages, 21 figures, LaTex, 2003, ApJ, 582 (Jan 1), in pres

Direct observation of size scaling and elastic interaction between nano-scale defects in collision cascades

Using in-situ transmission electron microscopy, we have directly observed nano-scale defects formed in ultra-high purity tungsten by low-dose high energy self-ion irradiation at 30K. At cryogenic temperature lattice defects have reduced mobility, so these microscope observations offer a window on the initial, primary damage caused by individual collision cascade events. Electron microscope images provide direct evidence for a power-law size distribution of nano-scale defects formed in high-energy cascades, with an upper size limit independent of the incident ion energy, as predicted by Sand et al. [Eur. Phys. Lett., 103:46003, (2013)]. Furthermore, the analysis of pair distribution functions of defects observed in the micrographs shows significant intra-cascade spatial correlations consistent with strong elastic interaction between the defects